HOW TO USE

• Usage
  Properly prepared exterior surfaces of wood, hardboard, aluminum siding, vinyl siding, masonry, brick, stucco, cement composition panels and metal. Not for use on floors.
• Prep
  Remove surface contaminants with an appropriate cleaner, rinse thoroughly and allow to dry. Remove peeled or damaged paint. Sand glossy surfaces dull. Seal stains with the appropriate primer. Caulk around windows, doors and other openings after spot priming bare surfaces. Knots and some woods, such as redwood and cedar, contain a high amount of tannin, a coloured wood extract. If applied to these unpainted woods, the first coat of paint may show some staining, but it will be trapped in the first coat. A second coat will uniform the appearance. If staining persists, spot prime severe areas with a stain-blocking primer.
• Application
  Stir paint thoroughly. Intermix containers for uniformity. When air temperature is 4.4°C, substrates may be colder; prior to painting, check to be sure the air, surface and material temperatures are above 4.4°C. Avoid using if rain or snow is expected within 2 hours. Do not apply when air or surface temperatures may drop below 4.4°C within 48 hours. On large expanses of metal siding, the air, surface and material temperatures must be 10°C or higher. No reduction necessary
  
• Dry Time
  Dry Time @ 25 °C (77 °F) and 50 % Relative Humidity
  To The Touch: 1 hour - 4 hour
  Recoat: 2 hour - 4 hour
• Clean-up & Disposal
  Clean up with warm, soapy water. Do not pour unused contents down the drain. Consult with local authorities for proper method of disposal and recycling